Noise reduction is generally accomplished by applying appropriate noise control treatments at strategic locations. Noise control treatments consisting of poroelastic materials in layers are extensively used in noise control products. Sound propagation through poroelastic materials is governed by macroscopic material and geometric properties. Thus, a knowledge of material properties is important to improve the acoustical performance of the resulting noise control products. Since the direct measurement of these properties is cumbersome, these have been usually estimated indirectly from easily measurable acoustic performance metrics such as normal incidence sound transmission and/or absorption coefficient, measured using readily available impedance tube. The existing inverse characterization approaches fulfilled the estimation by curve fitting measured and predicted acoustic models. In this paper, in addition to the use of diffuse field performance metrics, a data driven machine learningRaveendra, Chris, Salvekar, Pinak, Raveendra, Ravi
Electric motor whine is a major NVH source for electric vehicles. Traditional mitigation methods focus on e-motor hardware optimization, which requires long development cycles and may not be easily modified when the hardware is built. This paper presents a control- and software-based strategy to reduce the most dominant motor order of an IPM motor for General Motors’ Ultium electric propulsion system, using the patented active Torque Ripple Cancellation (TRC) technology with harmonic current injection. TRC improves motor NVH directly at the source level by targeting the torque ripple excitations, which are caused by the electromagnetic harmonic forces due to current ripples. Such field forces are actively compensated by superposition of a phase-shifted force of the same spatial order by using of appropriate current. A feedforward harmonic current generation module is developed, which allows the application of harmonic current commands to a motor control system with adjustable magnitudeHe, Song, Peddi, Vinod, Chang, Le
In vehicle development, reducing noise is a major concern to ensure passenger comfort. As electric vehicles become more common and engine and vibration noises improve, the aerodynamic noise generated around the vehicle becomes relatively more noticeable. In particular, the fluctuating wind noise, which is affected by turbulence in the atmosphere, gusts of wind, and wake caused by the vehicle in front, can make passengers feel uncomfortable. However, the cause of the fluctuating wind noise has not been fully understood, and a solution has not yet been found. The reason for this is that fluctuating wind noise cannot be quantitatively evaluated using common noise evaluation methods such as FFT and STFT. In addition, previous studies have relied on road tests, which do not provide reproducible conditions due to changing atmospheric conditions. To address this issue, automobile manufacturers are developing devices to generate turbulence in wind tunnels. However, in wind tunnels, it isTajima, Atsushi, Ikeda, Jun, Nakasato, Kosuke, Kamiwaki, Takahiro, Wakamatsu, Junichi, Oshima, Munehiko, Li, ChungGang, Tsubokura, Makoto